FaultScore
See all results →
All makes Worst years, ranked Problems by part Analysis Problems by model year Recalls in Canada Recall lookup Compare two cars How we grade

Mazda 929 recalls

NHTSA has issued 5 recalls covering the Mazda 929. A recall repair is always free, however old the car is.

Check your own car by VIN

Recalls apply to specific build ranges, so a recall listed here may or may not cover your particular vehicle. NHTSA's free VIN lookup is the authority: nhtsa.gov/recalls.

1988 Mazda 929 Campaign 95V103005 24 May 1995

SEAT BELTS:FRONT:BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Risk: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

1989 Mazda 929 Campaign 95V103005 24 May 1995

SEAT BELTS:FRONT:BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Risk: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

1991 Mazda 929 Campaign 95V103005 24 May 1995

SEAT BELTS:FRONT:BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Risk: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

1988 Mazda 929 Campaign 93V174000 29 Oct 1993

STRUCTURE:BODY:DOOR

RESIN MOLDED FRONT HANDLES FAIL AT THE DOOR LATCH ACTUATING ROD ATTACHMENT, FREEING THE ROD TO FALL INSIDE THE DOOR FRAME. SUBSEQUENT LOWERING OF THE ASSOCIATED WINDOW MAY FORCE THE ACTUATING ROD DOWNWARD AND RELEASE THE DOOR LATCH.

Risk: INADVERTENT ACTUATION OF THE DOOR LATCH CAUSES THE DOORTO OPEN UNEXPECTEDLY WHICH COULD RESULT IN AN OCCUPANT FALLING OUT OF THEVEHICLE.

Remedy: DEALERS WILL REPLACE THE DOOR HANDLE/LATCH ASSEMBLY.

1989 Mazda 929 Campaign 93V174000 29 Oct 1993

STRUCTURE:BODY:DOOR

RESIN MOLDED FRONT HANDLES FAIL AT THE DOOR LATCH ACTUATING ROD ATTACHMENT, FREEING THE ROD TO FALL INSIDE THE DOOR FRAME. SUBSEQUENT LOWERING OF THE ASSOCIATED WINDOW MAY FORCE THE ACTUATING ROD DOWNWARD AND RELEASE THE DOOR LATCH.

Risk: INADVERTENT ACTUATION OF THE DOOR LATCH CAUSES THE DOORTO OPEN UNEXPECTEDLY WHICH COULD RESULT IN AN OCCUPANT FALLING OUT OF THEVEHICLE.

Remedy: DEALERS WILL REPLACE THE DOOR HANDLE/LATCH ASSEMBLY.

Mazda 929 recalls in Canada

Transport Canada runs its own recall programme. Its campaigns do not always mirror the American ones, so a Canadian owner reading a US-only list is reading about a different car than the one on their driveway.

1994 Mazda 929 Recall 2015489 19 Oct 2015 232,227 units in Canada

Electrical

On certain vehicles, a defect in the ignition switch could cause an electrical short to develop over time. This could result in smoke and/or fire, increasing the risk of injury and/or damage to property. Correction: Dealers will replace the ignition switch.

1993 Mazda 929 Recall 2015489 19 Oct 2015 232,227 units in Canada

Electrical

On certain vehicles, a defect in the ignition switch could cause an electrical short to develop over time. This could result in smoke and/or fire, increasing the risk of injury and/or damage to property. Correction: Dealers will replace the ignition switch.

1988 Mazda 929 Recall 1995085 24 May 1995 48,568 units in Canada

Seats And Restraints

THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.

1989 Mazda 929 Recall 1995085 24 May 1995 48,568 units in Canada

Seats And Restraints

THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.

1991 Mazda 929 Recall 1995085 24 May 1995 48,568 units in Canada

Seats And Restraints

THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.

1990 Mazda 929 Recall 1995085 24 May 1995 48,568 units in Canada

Seats And Restraints

THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.

1988 Mazda 929 Recall 1994027 10 Feb 1994 19,683 units in Canada

Structure

NOTE: 626 - 16,682 UNITS. 929 - 3,001 UNITS. THE FRONT OUTER DOOR HANDLES CAN PREMATURELY FAIL AT THE POINT WHERE THE HANDLE CONNECTS TO THE ROD THAT ACTIVATES THE DOOR LOCK. IF THE ROD WERE TO FALL INBOARD INTO THE PATH OF THE WINDOW GLAZING, LOWERING THE WINDOW COULD RESULT IN PRESSURE ON THE ROD AND COULD CAUSE THE DOOR TO INADVERTENTLY OPEN IF UNLOCKED. CORRECTION: A SAFETY SHIELD WILL BE INSTALLED BETWEEN THE OUTER SURFACE OF THE WINDOW GLAZING AND THE DOOR HANDLE OPERATING MECHANISM.

1989 Mazda 929 Recall 1994027 10 Feb 1994 19,683 units in Canada

Structure

NOTE: 626 - 16,682 UNITS. 929 - 3,001 UNITS. THE FRONT OUTER DOOR HANDLES CAN PREMATURELY FAIL AT THE POINT WHERE THE HANDLE CONNECTS TO THE ROD THAT ACTIVATES THE DOOR LOCK. IF THE ROD WERE TO FALL INBOARD INTO THE PATH OF THE WINDOW GLAZING, LOWERING THE WINDOW COULD RESULT IN PRESSURE ON THE ROD AND COULD CAUSE THE DOOR TO INADVERTENTLY OPEN IF UNLOCKED. CORRECTION: A SAFETY SHIELD WILL BE INSTALLED BETWEEN THE OUTER SURFACE OF THE WINDOW GLAZING AND THE DOOR HANDLE OPERATING MECHANISM.

1990 Mazda 929 Recall 1991014 18 Jan 1991 7,825 units in Canada

Lights And Instruments

THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING. WHEN THE TURN SIGNAL IS SWITCHED ON, BOTH DRL'S ARE EXTINGUISHED AND THE TURN SIGNAL IS ACTIVATED. THIS MODE OF OPERATION IS CONTRARY TO THE REQUIREMENTS OF THE STANDARD. SUBSECTION 16 AND 19(b) (iii). CORRECTION: DRL CONTROL UNIT WILL BE REPLACED WITH ONE THAT WILL ENSURE THAT THE SYSTEM'S OPERATION MEETS THE STANDARD.

1988 Mazda 929 Recall 1988009 20 Jan 1988 989 units in Canada

Emissions

THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1105 - EVAPORATIVE EMISSIONS. V.I.N. RANGE - JM1HC2210J0100001 TO JM1HC2216J0113013

Source: Transport Canada Vehicle Recalls Database.