FaultScore

BMW 128I engine problems

62 of the 237 complaints filed about the BMW 128I are about the engine — 26% of everything owners reported. The worst model year for it is 2011.

62

Complaints

26%

Share of all complaints

0

Crashes

8

Fires

Engine & Cooling complaints by model year

2008 128I 4 6.5%

Median failure at 120,000 miles

2009 128I 8 12.9%

Median failure at 81,250 miles

2010 128I 10 16.1%

Median failure at 105,000 miles

2011 128I 26 41.9%

Median failure at 113,000 miles

2012 128I 6 9.7%

Median failure at 79,769 miles

2013 128I 8 12.9%

Median failure at 43,500 miles

What owners said

2012 BMW 128I Pittsburgh, PA

ENGINE

Prior to August 2024, this vehicle operated with zero check engine lights or drivetrain faults. In August 2024, BMW of Pittsburgh executed federally mandated Safety Recall 23V-707, which required opening the cylinder head. Immediately following this service, the Check Engine Light began illuminating persistently.On or about October 3, 2024, an independent diagnostic scan at Bobby Rahal BMW pulled BMW Factory Code 002A89: Exhaust VANOS Camshaft Mechanism Fault (Mechanical Sticking/Flow Restriction). Technicians at Bobby Rahal BMW explicitly instructed me to return the car to BMW of Pittsburgh because they suspected the original VANOS safety recall repair was botched.On October 28, 2024, I returned the vehicle to BMW of Pittsburgh to address this issue. Their technicians opened the engine block assembly a second time, yet failed to correct the defect. Following this second visit, the check engine light continued to come on intermittently. The vehicle began suffering rough idling, difficulty starting, and dangerous stalling events during operation. Cycling the ignition on and off provided only temporary relief.The check engine light has now become permanently illuminated. The safety hazards have severely escalated into a protective engine "limp mode," causing violent drivetrain shuddering and a catastrophic loss of driveability. BMW of Pittsburgh refuses to honor the recall workmanship, demanding a predatory $6,000 out-of-pocket teardown fee to bypass their liability. The manufacturer (BMW North America) has been notified under Case Reference VH78028, but the safety defect remains unaddressed, and the vehicle is completely unsafe to drive.

NHTSA complaint #11738803 — an unverified report by a vehicle owner.

2012 BMW 128I Belleville, IL

ENGINE

Due to BMW using plastic parts when you live in Hot and cold environments the plastic begins to mold to other plastic parts and pvc diaphragms tear rather easy causing rough idle , stalls and can cause over revving and send a car into another car while in gear. The cheap plastic cause oil leaks and when oil gets low cause engine failure as well.

NHTSA complaint #11726596 — an unverified report by a vehicle owner.

2012 BMW 128I Miami, FL

ENGINE

On February 25, 2026, BMW of South Miami performed the VANOS safety recall repair on my vehicle. The repair order documented that VANOS bolts were missing and retrieved from the engine oil pan and that VANOS components were serviced. Within approximately 24–48 hours of picking up the vehicle, the check engine light illuminated and the vehicle began operating abnormally, including rough idle and irregular shifting. The vehicle stored diagnostic fault code P054B (camshaft position timing over-retarded), which directly relates to camshaft timing and the VANOS system involved in the recall repair. I returned the vehicle to the dealership for further diagnosis. The dealership stated an aftermarket camshaft position sensor with two O-rings was installed and removed one O-ring to correct the gap between the sensor and the camshaft reluctor wheel. The faults were cleared and the vehicle was returned to me. However, the check engine light returned again the following morning upon cold start, indicating the issue was not corrected. My service advisor has since stated that replacing the camshaft position sensor is not part of the recall repair and the dealership has declined to repair the vehicle under the recall. Because the malfunction appeared immediately after the VANOS safety recall repair and involves the camshaft timing system connected to VANOS operation, I believe the recall repair may not have been properly completed or corrected. I am requesting that NHTSA review this matter as a potential recall effectiveness issue, as the safety recall repair appears unresolved and the vehicle continues to experience faults related to the system that was repaired.

NHTSA complaint #11722577 — an unverified report by a vehicle owner.

2013 BMW 128I Sacramento, CA

ENGINE

On or about 2022 I was given notice of recall which told me to go to any BMW dealer for repair. I went to Niello BMW in Sacramento. I was getting car processed and then told to summarily leave. They refused to repair my car per recall notice

NHTSA complaint #11688526 — an unverified report by a vehicle owner.

2011 BMW 128I at 120,000 miles Stockbridge, GA

ENGINE

The contact owns a 2011 BMW 128I. The contact stated that on several occasions while driving at various speeds, the vehicle hesitated. The contact stated that on one occasion while driving at an undisclosed speed, the vehicle hesitated and then stalled. The vehicle was not able to restart. The vehicle was towed to the residence. The vehicle was then towed to a dealer, where it was diagnosed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 120,000.

NHTSA complaint #11649325 — an unverified report by a vehicle owner.

2009 BMW 128I Blackwood, NJ

ENGINE

VANOS chamshaft bolts broke, and had to pay $3,200 to replace assembly, and restore timing in engine. There is currently an open recall for 2010+ models but the problem still occurs on 2009 models as well. This is a huge risk for drivers as the car can randomly stall and cause fatal accidents and/or financial burden. This problem has been addressed for earlier models, and needs to be held to the same standard for later models with the same engine.

NHTSA complaint #11631292 — an unverified report by a vehicle owner.

2009 BMW 128I Fresno, CA

ENGINE AND ENGINE COOLING

The contact owns a 2009 BMW 128I. The contact received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. Parts distribution disconnect.

NHTSA complaint #11622707 — an unverified report by a vehicle owner.

2013 BMW 128I Long Valley, NJ

ENGINE AND ENGINE COOLING

See attached document for complaint.

NHTSA complaint #11611643 — an unverified report by a vehicle owner.

2009 BMW 128I Los Angeles, CA

ENGINE

My electric water pump failed and my car overheated 3 times (once resulting in thick white smoke coming from the engine) tow trucks were called and fire department notified. Car is now unused on drive way as it just overheats constantly when turned on.

NHTSA complaint #11609838 — an unverified report by a vehicle owner.

2011 BMW 128I at 102,000 miles Knoxville, TN

ENGINE AND ENGINE COOLING

The contact owns a 2018 BMW 128I. The contact stated while driving at various speeds, the vehicle stalled. While at a stop sign, the vehicle stalled. The check engine warning light was illuminated. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 102,000. VIN tool confirms parts not available.

NHTSA complaint #11603452 — an unverified report by a vehicle owner.

2012 BMW 128I North Tonawanda, NY

ENGINE AND ENGINE COOLING

The contact owns a 2012 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA complaint #11600565 — an unverified report by a vehicle owner.

2011 BMW 128I Stockbridge, GA

ENGINE AND ENGINE COOLING

The contact owns a 2011 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The local dealer was contacted and confirmed no parts were available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA complaint #11594438 — an unverified report by a vehicle owner.

2010 BMW 128I Nashville, TN

ENGINE

First notified of recall in October, 2023. After 8 months, BMW tells me there is no remedy available. Eight months is more than a reasonable amount of time to remedy this defect. Please help! Thank you.

NHTSA complaint #11594093 — an unverified report by a vehicle owner.

2011 BMW 128I Laurel Hill, FL

ENGINE AND ENGINE COOLING

The contact owns a 2011 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA complaint #11592796 — an unverified report by a vehicle owner.

2010 BMW 128I Nashville, TN

ENGINE AND ENGINE COOLING

The contact owns a 2010 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA complaint #11589620 — an unverified report by a vehicle owner.

2011 BMW 128I Lady Lake, FL

ENGINE AND ENGINE COOLING

The contact owns a 2011 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA complaint #11589636 — an unverified report by a vehicle owner.

2011 BMW 128I Boerne, TX

ENGINE AND ENGINE COOLING

The contact owns a 2011 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The local dealer was contacted, and it was confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA complaint #11586514 — an unverified report by a vehicle owner.

2011 BMW 128I at 149,000 miles Channelview, TX

ENGINE AND ENGINE COOLING

The contact owns a 2011 BMW 128I. The contact stated while driving at approximately 50 MPH, the vehicle was jerking and there was a hard vibration. The contact also stated that the vehicle experienced an intermittent unintended acceleration. The local dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 149,000.

NHTSA complaint #11585268 — an unverified report by a vehicle owner.

2011 BMW 128I at 140,000 miles Lakewood, CA

ENGINE AND ENGINE COOLING

The contact owns a 2011 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that while stopped at a traffic signal, the contact heard an abnormal rattling sound coming from the engine compartment. The contact stated that the check engine warning was illuminated. The contact stated that he depressed the accelerator when the traffic signal changed, and the rattle was louder. The contact drove the vehicle back to the residence and parked. The vehicle was not taken to a dealer or independent mechanic. The vehicle was not diagnosed or repaired. The contact related the failure to NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling). The failure mileage was approximately 140,000. VIN tool confirms parts not available.

NHTSA complaint #11584776 — an unverified report by a vehicle owner.

2011 BMW 128I at 140,000 miles Lakewood, CA

ENGINE

The contact owns a 2011 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that while stopped at a traffic signal, the contact heard an abnormal rattling sound coming from the engine compartment. The contact stated that the check engine warning was illuminated. The contact stated that he depressed the accelerator when the traffic signal changed, and the rattle was louder. The contact drove the vehicle back to the residence and parked. The vehicle was not taken to a dealer or independent mechanic. The vehicle was not diagnosed or repaired. The contact related the failure to NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling). The failure mileage was approximately 140,000. VIN tool confirms parts not available.

NHTSA complaint #11584776 — an unverified report by a vehicle owner.

Other BMW 128I problems