The contact owns a 2011 Mazda Mazda3. The contact stated that while operating the vehicle, the front driver’s side seat wobbled and was unsecured. The vehicle was taken to the local dealer, who determined that the front driver’s side seat lifter link was inoperable and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was provided. The contact was informed that the VIN was not included in NHTSA Campaign Number: 17V082000 (SEATS). The contact stated that the vehicle had experienced the failure listed in the recall. Additionally, the contact stated that the dashboard was melted and warped. The contact was concerned that the front air bags would not properly deploy due to the warped dashboard housing in the front driver and passenger side air bags. The failure mileage was 167,850.
NHTSA complaint #11750889 — an unverified report by a vehicle owner.
The Seat Lifter on the driver's side seat frame broke, the metal has a clear stress fracture right near the bracket where the frame connects to the rail. This is the same part that was recalled in the 2010 and 2011 Models by Mazda in 2017. NHTSA Campaign No. 17V-082 It causes the driver side seat to change positions while driving creating hazardous conditions and does not appear structurally stable if involved in an accident potentially putting the driver's life at risk.
NHTSA complaint #11659410 — an unverified report by a vehicle owner.
This vehicle is subject to recall #: 17V-082 referring to a drivers seat lifter link than can break. My car has a broken lifter link, was brought to the dealership and instead of replacing the entire seat adjuster unit like the recall states, they simply installed a reinforcement bracket. When brought back to Med Center Mazda they state it has already been repaired and therefore cannot be repaired again. The vehicle still has a broken seat lifter link.
NHTSA complaint #11643478 — an unverified report by a vehicle owner.
Defective Driver's seat construction made by Mazda Mfg Corp. I was the first person to report this cheaply made driver's seat failure to Mazda Corp in Irvine, CA in early 2015 or 2016. Recall was finally issued a year afterwards because Mazda dragged their feet, and only after I threatened to sue them if I was ever in an accident, and the seat was to totally fall apart, and maim me for life did they finally take action. The Recall fix (cheap bandaid clamp that again failed because seat frame welds had failed as well) was never done right, and as a result the seat totally fell apart, and Ed Howard Lincoln Mazda of Sarasota, FL didn't want to do anything further at that point (cost out of pocket wise). I was told by a different Mazda Dealership in Ft Myers, FL that that defective seat should have been totally replaced if they would've handled it correctly. So Ed Howard Lincoln Mazda really screwed me on that one! As related to the 2.5L Mazda engine, I also had/have a engine failure part there as well. It's called the ENGINE COOLANT (WATER) OUTLET FLANGE, and the bottom left hand bolt (1 of 4 bolts total) that's suppose to hold this cheap plastic part in place was stripped (over-torqued) at the production assembly line time that the engine was made (put together). Now the cheap plastic replacement part is leaking again from the same lower left hand corner, and this is a well Known Ford & Mazda 2.5L engine failure design as stated in many a Mazda online forum! This also should have been recalled, as now my 2011 Mazda 3 is down again. Engine overheated again on Oct 13, 2023. Prior repair to replace this defective Flange was done in Feb or Mar of 2022. Cheap Plastic parts put on a Metal engine just don't work well at all. Common Physics would tell you that! I have documents in my storage unit if you need them.
NHTSA complaint #11567016 — an unverified report by a vehicle owner.
Monday 7/10/2023 car was fine ie (the seat) next day Tues 7/11/2023 opened drivers side door couldn’t believe my eyes. The driver seat had somehow migrated clear up to an inch from my chest to the steering wheel. I called Maple Shade Turnersville to make an appointment-wasn’t able to get in until 7/20/2023. I was told I had to return on 7/24/2023. Did that. Appt was 7:30AM. Was given a loaner car. At around 10:30 Am Mazda Tuenersville called to ask me to return the loaner (?). When I arrived Pat Kearny told me he couldn’t do anything to help with the car seat. Told me my car was too old that they didn’t make parts for my 2010 Mazda 3 for the already recalled seat problems. Now I’m in a big bind. My steering wheel is one inch from my chest. I am very upset what happened here.
NHTSA complaint #11536183 — an unverified report by a vehicle owner.
The contact owns a 2010 Mazda Mazda3. The contact stated upon opening the driver's side door, she noticed that the front driver's side seat had independently moved closer to the steering wheel. The contact stated that the seat failed to move back to the original position after several attempts. There was no warning light illuminated. The contact was able to squeeze herself into the seat and drove to the dealer, who informed the contact that the driver's side seat bolts needed to be broken to move the seat. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 17V082000 (Seats); however, the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was approximately 61,000.
NHTSA complaint #11534324 — an unverified report by a vehicle owner.
Driver seat rocks back and forth. There was a recall for 2010-2011 models for this exact issue but 2012 and 2013 are not included in the recall. This is an issue for later models and was even an issue for the 2014-2018 as a separate recall was issued for that generation. 2012 and 2013 need to be recalled for the seats rocking back and forth. This is a safety concern.
NHTSA complaint #11526758 — an unverified report by a vehicle owner.
The seat track on the drivers seat has come apart, so now the drivers seat rocks back and forth with every acceleration and brake, and feels like it's about to come off entirely. There was no incident that seemed to cause this, just one day I got in the car and the seat was loose. I took it to the dealership and they confirmed the seat track is coming apart, but there is no recall out for this VIN so I would have to pay $2400 to replace this defective part.
NHTSA complaint #11517801 — an unverified report by a vehicle owner.
My seat lifter broke causing the driver's seat to rock back and forth. I brought my vehicle to my local dealer on 05/18/2022 to have an outstanding NHTSA recall 17V-082 performed to repair the issue. I was informed that the necessary part to repair the seat was on backorder and there was no ETA, but that I would be contacted when a part was available. Over the following nine months, I periodically followed up to see if they had received the part, culminating with being told by the dealer on 03/02/2023 that the part order was canceled and flagged as no longer available and that I needed to contact Mazda directly. I then called Mazda, who told me that the part was indeed marked as retired and advised that I seek an aftermarket replacement, of which none is available. They did check in my local area and found only one remaining part in a dealer's inventory, which I'll be driving to on 03/11/2023 to have the repair done. There has been no consideration made by Mazda for my safety while driving the vehicle, and for anyone still requiring this repair, the part is "retired" and no longer available from Mazda for an open recall.
NHTSA complaint #11509936 — an unverified report by a vehicle owner.
Nothing has happened yet but Ive done a bunch of research and a lot of the 3rd generation Mazda 3's all have the same airbag code 16 flashing on their dash and it's not on any recall list
NHTSA complaint #11503213 — an unverified report by a vehicle owner.
When adjusting the driver seat, the vehicle began to display "Air Bag System Malfunction. Have the vehicle inspected." This was with roughly 20 total miles on the odometer. It is a new car - Mazda3 Turbo Sedan 2022. After researching online, this is a very common problem with new Mazda3s and there are many customers with the exact same issue. The customers have also made complaints to the NHTSA. Mazda has a technical service bulletin for this problem (Bulletin no:08-001/22) and states the issue is due to "Driver-side air bag module circuit: open circuit or resistance high". This issue also occurs on the passenger-side air bag. It is a possibility that I could have been in an accident and the side airbag would not function. Or even perhaps the air bag may have had an electrical error and engaged itself while I could have been driving. My local dealership has verified the issue, however, they still have not been able to correct the issue after 8 weeks. So I have had to use a loaner for 7 weeks now. In summary, I'm filing a complaint because 1)This issue is so common 2)It pertains to something crucially important to safety 3)This is occurring almost immediately after purchase 4)Mazda does not seem to be able to readily and quickly fix the issue.
NHTSA complaint #11470333 — an unverified report by a vehicle owner.
The contact owns a 2011 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 17V082000 (Seats) however, the part to do the recall repair was not yet available. The local dealer was contacted several times. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact stated that the front driver's seat was unsteady while driving and the failure had been recurring since 2017. The vehicle was not diagnosed or repaired. The failure mileage was approximately 100,000. Parts distribution disconnect.
NHTSA complaint #11458692 — an unverified report by a vehicle owner.
Driver seat has become loose and rocks forward in an up and down fashion while driving. Can be rock by hand as well when not sitting in the seat. A prior recall addressed this issue with 2010-2011 Mazda 3's. This is a 2012 that is having the same problem, but the recall does not apply to it. The recall needs to be expanded to included all vehicles experiencing this issue. NHTSA Campaign Number: 17V082 Manufacturer Mazda North American Operations Components SEATS Potential Number of Units Affected 173,859
NHTSA complaint #11446147 — an unverified report by a vehicle owner.
The contact owns a 2012 Mazda Mazda3. The contact stated while at a standstill, she heard a popping sound coming from the driver’s side seat resulting in the seat moving and not maintaining an appropriate driving position. The vehicle was not taken to a dealer to be diagnosed. Upon investigation, the contact associated the failure with NHTSA Campaign Number: 17V082000 (Seats) however, the VIN was not included. The manufacturer was not informed of the failure. The failure mileage was approximately 95,000.
NHTSA complaint #11436695 — an unverified report by a vehicle owner.
Power seat sliding mechanism on drivers side when actuating the forward and reverse lever is extremely noisy. The noise started at around 45000 miles when the car was 3 years old. I was able to make the repair myself after finding a tsb on nhtsa.gov. https://static.nhtsa.gov/odi/tsbs/2018/MC-10143977-9999.pdf. Required part # can found in this tsb. The original part is defective. Dealer will make the repair for $800 plus. You can do it yourself for $25. The actual repair is extremely simple. Also there is no reason to remove the seat bolts as done in the tsb.
NHTSA complaint #11421735 — an unverified report by a vehicle owner.
The seat height adjustment lifter link has broken and my driver seat wobbles tilting up and down during normal operation. There is a recall for this exact issue for this exact model of vehicle 2011 Mazda 3.
NHTSA complaint #11421476 — an unverified report by a vehicle owner.
My exact make and model and year was recalled in 2017 for a driver seat problem. My specific vehicle avoided recall because it was manufactured in November 2010, as the recall only included those manufactured up until September 2010. How is it that my vehicle had the same EXACT problem of those models but was not included? The seat lifter clamp BROKE-the same exact problem warned about in the recall. I can't afford the $800 repair and this is NOT even my fault.
NHTSA complaint #11420995 — an unverified report by a vehicle owner.
EXACT SAME ISSUE AS CAMPAIGN NUMBER: 17V082 THE SEATS IN THIS YEAR OF MAZDA 3 ARE THE SAME AS IN THE 2010-2011 MODELS. THE METAL HAS SNAPPED IN HALF CAUSING THE NEED FOR REPAIR FOR SAFE DRIVING. THIS HAPPENED WHILE TURNING A CORNER ON A CITY STREET GOING ABOUT 30KM/H DRIVER IS 260LBS
NHTSA complaint #11415704 — an unverified report by a vehicle owner.