The contact owns a 2026 Ram 3500. The contact stated that while driving at an undisclosed speed, several unknown warning lights were illuminated. The message that the trailer was not connected was displayed. The contact received notification of NHTSA Campaign Number: 26V059000 (Exterior Lighting, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was 11,000.
NHTSA complaint #11758321 — an unverified report by a vehicle owner.
The contact owns a 2021 Ram 3500. The contact stated that while driving at various speeds, occasionally while activating the left turn signal to make a turn, the rear driver’s side turn signal failed to operate as intended. The message related to the brake light and turn signal was displayed on the instrument panel. In addition, the contact stated that while driving at various speeds, the rear driver’s side brake light failed to operate as intended while depressing the brake pedal. Additionally, while shifted into reverse(R), the reverse warning light fail to illuminate as intended. The vehicle was taken to a local dealer, where the failure was associated with NHTSA Campaign: 24V197000 (Electrical System, Exterior Lighting); however, the VIN was not included. The vehicle was not repaired due to the cost. The manufacturer was made aware of the failure. The failure mileage was approximately 6,000.
NHTSA complaint #11747714 — an unverified report by a vehicle owner.
This model of truck has 4 led lights that will never turn off. Using the switch in the cab does not affect them. When the headlight switch is in off, manual, or parking - these lights remain on. Additionally, there is no setting in the software that provides control over these lights. I have interacted with Stallantis Customer Service, and my local dealer -both state: "Lights are working as designed". Contrary to this, the owners manual states that the lights can be turned off using the switch. There are times, after dark, where parking lights are appropriate, but headlights are not. It seems to me a design flaw and dangerous to give the operator of the vehichle zero control over these "halo lights".
NHTSA complaint #11743207 — an unverified report by a vehicle owner.
Trailer Brake Module recall was completed. Now getting random error messages and lights advising trailer disconnected, etc. even without a trailer being hooked to the truck.
NHTSA complaint #11735442 — an unverified report by a vehicle owner.
The contact owns a 2025 Ram 3500. The contact received a recall notification of NHTSA Campaign Number: 26V059000 (Exterior Lighting, Electrical System); however, when the local dealer was contacted, the contact was informed that the manufacturer was shipping a very limited number of parts to dealers for the repair. The manufacturer was contacted, and the contact was informed that the dealer should request an expedited shipment. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The vehicle was not repaired. The contact had not experienced a failure.
NHTSA complaint #11731063 — an unverified report by a vehicle owner.
The contact owns a 2026 Ram 3500. The contact received notification of NHTSA Campaign Number: 26V059000 (EXTERIOR LIGHTING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact called a dealer while traveling in Braunfels, Texas, and asked about parts availability. The dealer stated that the manufacturer was providing only one part per week to the dealer location, which was causing a long wait for the recall repair. A second dealer, Miller Motor Sales Chrysler Dodge Jeep Ram (1196 Milwaukee Ave, Burlington, WI 53105) was contacted and confirmed the limited part supply to the dealer. The manufacturer was not made aware of the issue. The contact had not experienced a failure.
NHTSA complaint #11726903 — an unverified report by a vehicle owner.
This complaint involves a 2024 Ram 3500 with an unresolved electrical system issue associated with the rear backup camera and related wiring. The vehicle initially presented with a malfunctioning backup camera, including unclear or distorted image quality, which affects rear visibility and safe operation while reversing. The vehicle was taken to authorized dealerships for repair on multiple occasions. During the course of these repair attempts, the wiring associated with the system was damaged, resulting in an ongoing electrical system issue that has not been resolved. The vehicle has now been out of service for approximately 71 days. Most recently, the authorized dealership confirmed that the required parts to complete the repair are unavailable, there is no estimated timeline for parts availability, and the repair cannot be completed at this time. As a result, there is currently no repair plan in place. This situation raises safety concerns due to the loss of a critical safety feature (rear visibility via the backup camera) and the presence of unresolved electrical system damage. Damaged or compromised wiring may create the potential for electrical malfunction, system instability, or other hazards if the vehicle were to be operated. The inability to repair the vehicle, combined with the lack of available parts and absence of any repair timeline, raises concerns about the overall safety and reliability of the vehicle. The vehicle remains at the dealership and is available for inspection.
NHTSA complaint #11726867 — an unverified report by a vehicle owner.
The contact owns a 2025 Ram 3500. The contact received notification of NHTSA Campaign Number: 26V059000 (EXTERIOR LIGHTING, ELECTRICAL SYSTEM). The contact noticed the failure on the drive back after the vehicle was purchased. The contact stated that on a separate occasion, while driving at an undisclosed speed, the brake lights and turn signals failed to function as intended. The contact lived in a rural area and stated that at night it is dark, and the brake lights nor the turn signals were operable. The contact felt that the vehicle was unsafe to drive. The local dealer was contacted, and the contact was informed that the parts for the recall repair were available. However, the parts were allocated to unsold vehicles first, and there was no estimated time for the recall part to be available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue and confirmed with the dealer about the part not being available. The contact was informed that the recall part was blocked from manual ordering. The failure mileage was approximately 500.
NHTSA complaint #11722979 — an unverified report by a vehicle owner.
Contacted local Dodge dealer for repair of the below known part issue. They stated they are only receiving 1 unit/week to be able to replace and the repair could be weeks out. I use my truck for towing frequently and am not comfortable doing so with the upcoming recall known. Manufacturer Recall Number03D NHTSA Recall Number26V-059 Recall StatusRecall Incomplete
NHTSA complaint #11717503 — an unverified report by a vehicle owner.
Both front ball joints wore out at 20,000 miles The 3rd break light leaks into the cab at 26,000 miles & won't be warrantied even though there's an active recall for our same truck, same part just different model
NHTSA complaint #11708936 — an unverified report by a vehicle owner.
Every time I turn my left turn signal on my headlights high beams come on weather headlights are turned on or not even if I have my headlights on on low beam, it does not do it when I turn my right turn signal on. It does it whether I have my auto headlights on or off. I'm sure it's been happening longer than that that's just the first time I was informed by someone I was following on the highway
NHTSA complaint #11674538 — an unverified report by a vehicle owner.
SCCM Internal failure that the dealer is calling an Air Bag Clock Spring failure. Safety Recall 33B and 14B already exist for my make and year of vehicle, but do not cover my VIN. The turn signal gets stuck leading to a hazard for the operator and those around.
NHTSA complaint #11663759 — an unverified report by a vehicle owner.
Despite having taken my 2023 Ram 3500 HD truck to the Ram dealer 3 times for the same recall, the issue still persists. The recall in question is B2A/NHTSA 23V-799 related to a malfunctioning SCCM that results in high beams activating with left turn signal activation. Also, left turn signal activates with high beam pass activation. Per Ram's protocol, they performed a software reboot upon the first attempt. The problem quickly returned. I returned to the same service department who did not perform any service on the vehicle despite the ongoing problem for more than one week. I took the truck back as it was my main mode of transportation. Because this safety issue has not resolved, I attempted to take it back to a different Ram service center who wanted to perform some incredibly involved electronic disconnection of all systems. I told them this was unacceptable because this was a known recall item that is still active. I have tried calling Ram Cares Customer service, but they have been entirely unhelpful. I am not filing this safety issue because Ram refuses to provide the needed replacement of the SCCM unit, which was the correct fix for this recall because they insist that the recall has been serviced appropriately. I have a recent video that shows the problem still happening, but they have not cared to look at it.
NHTSA complaint #11621770 — an unverified report by a vehicle owner.
I have problem with rear window light water leak. This light has water leak and I have a lot of water after each rain. Many of my things were destroyed because of this. I know RAM has reacalls for this huge problem, but they denied to fix my car, because there is no this recall under my VIN. But I read a lot of comments on RAM forums and many people complaining about this issue. I also saw that some people were able to fix it under the recall but I don't have any idea who I should contact for help. I need them to fix this issue in my car also, because this is manufacture issue not because of me
NHTSA complaint #11617719 — an unverified report by a vehicle owner.
Turn on left blinker and the high beams come on doesn’t matter if it’s daytime, night time, headlights on or off, truck running not running. Obviously you don’t want to high beam other drivers when passing on left or turning left. Opened driver door and passenger rear window shattered with 2800 miles on it.
NHTSA complaint #11557360 — an unverified report by a vehicle owner.
Steering components broke when turning the truck around, this happened 30 miles up a Forest service rd. while out sightseeing. Had to be towed a long way ($1200) for the towing. and the steering repair for $1150.00, if this would have happened at speed when we were towing our camper it would have been terrible. This truck has no off-road usage other than for snow. Head light low beam on the drivers side stopped working, traced the wire back to the TIPM and there is no power coming out for this wire. Reading up on this issue it seems to be a very standard problem in 2006 and above trucks. This should be a recall item as it can cause serious problems when driving at night or in bad weather. I have seen that the Tipm has been recalled on only certain models, this makes no sense to me. There were no warnings on either of these failures. The TIPM headlight problem is in the Dodge shop now trying to be resolved, the steering was repaired at another shop as we were out of town.
NHTSA complaint #11525539 — an unverified report by a vehicle owner.
The Auto lights sensor turns lights on/off at random during dark/night driving. The high beam auto sensor keeps the high beams on, so you do not notice losing driving lights. I found this out by accident, when I started losing my trailer lights at night. Quick fix, turn the light switch to on, instead of auto. NOTE - Cost me over 1000.00 to find that out. Re-wire the trailer, replace the 7-way plug.
NHTSA complaint #11482571 — an unverified report by a vehicle owner.
when using the automatic rain wipers with automatic headlights activated during the daytime the dash illumination is darken to night time values. Since the dash is digital along with the radio system, it is EXTREMELY difficult to see anything. It requires you take take your eyes off the road for a longer period to time to view any information on the dash or in the navigation/radio. The dash illumination should never darken during the daytime, unless the light value is decreased to what a nightime value would be.
NHTSA complaint #11474589 — an unverified report by a vehicle owner.
Uconnect 12” Screen Blinds Driver With Full Brightness in Reverse. There is a software issue with the Uconnect 12” screen in RAM trucks. The issue arises in dark unlit areas when the truck is put in reverse, the Uconnect 12” screen is automatically switched to full brightness, resulting in blinding the driver so the side rear view mirrors become useless. There is no way for the driver to override this max brightness when in reverse. The Uconnect 12” screen should maintain its current level of brightness when the driver places the truck in reverse and not default to max brightness. In urban areas this may not be as significant issue as it is in rural areas. Many times, I have had to throw a heavy blanket, jacket, or sweatshirt over the screen so I would not be blinded by its increase to max brightness when putting the truck in reverse. This issue is made significantly worse when trying to back a 30’ trailer in the dark and can no longer see anything from the side view mirrors due to the max brightness of the Uconnect 12” screen blinding me. This is similar to passing a car with their bright lights on, but they sit there until you take the truck out of reverse. This Uconnect 5 12” screen seems to be significantly brighter than the Uconnect 4 screen in my previous vehicle. This is a safety issue as it temporarily blinds the driver when in reverse and has already caused damage to one trailer. The Uconnect 12” should maintain the current level of brightness and not go to max brightness when the truck is put in reverse. Please make this a priority request for the next software release of the Uconnect 12”. Thank you!
NHTSA complaint #11453203 — an unverified report by a vehicle owner.